CCNA 200-125 Exam Dumps Part 7 Simulator Online

Which RPVST+ port state is excluded from all STP operations?

Which command can you enter to block HTTPS traffic from the whole class A private network range to a host?

When is a routing table entry identified as directly connected?

Which address block identifies all link-local addresses?

Which option is the industry-standard protocol for EtherChannel ?

For which two reasons was RFC 1918 address space define? (Choose two)

Which two statements about RIPv2 are true? (Choose two)

In which CLI configuration mode can you configure the hostname of a device?

In which two circumstances are private IPv4 addresses appropriate? (Choose two)

Which two statements about eBGP neighbor relationships are true? (Choose two)

Which two pieces of information can be shared with LLDP TLVs? (Choose two)

Which two statements about UDP are true? (Choose two)

Which two statements about access points are true? (Choose Two)

For which two protocols can PortFast alleviate potential host startup is-sues? (Choose two.)

What does it take for BGP to establish connection. (Choose two)

On which layer tcp/ip is ACL Apic-EM path

Which cloud service is typically used to provide DNS and DHCP services to an enterprise?

Which three statements about Syslog utilization are true? (Choose three.)

What are the two statements about EUI-64 addressing? (Choose two)

After you configure the ip dns spoofing command globally on a device,under which two conditions is DNS spoofing enabled on the device?(choose two)

Which task must you perform to enable an IOS device to use DNS services?

Which two IP SLA operations can you use to measure the end-to-end response time for all IP traffic between a Cisco router and an end device? (choose two)

What authentication type is used by SNMPv2 ?

Which MAC protocol sets a random timer to reattempt communication ?

While troubleshooting a GRE tunnel interface issue,show interface command output displays tunnel status up,but line protocol is down.
Which reason for this problem is most likely?

Which two statements about stacking Cisco switches are true ?(choose two)

Router R1 has a static route that is configured to destination network.A directly connected interface is configured with an IP address in the same destination network.Which statement about R1 is true?

Which type of address is the public IP address of a NAT device?

Which configuration register value can you set on a Cisco device so that it ignores the NVRAM when it boots?

Which two benefits can you get by stacking Cisco switches?(choose two)

Which command can you enter to verify that a router is synced with a configures time source?

Two statements about LLDP are true?(choose two)

A network administrator enters the following command on a router:logging trap 3 . What are three message types that will be sent to the Syslog server?(choose three)

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q34

Which statement is true?

Which technology allows a large number of private IP addresses to be represented by a smaller number of public IP addresses?

Which two types of NAT addresses are used in a Cisco NAT device? (Choose two.)

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q37

A new subnet with 60 hosts has been added to the network. Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q38

If the devices produced the given output,what is the cause of the EtherChannel problem?

Which option is a valid IPv6 address?

Which two statements about configuring an Ether Channel on a Cisco switch are true?(Choose two)

Which two statements about IPv6 anycast addresses are true?( Choose two)

What is the first step in the NAT configuration process?

It you change the weight and distance parameters on a device with an establshed BGP neighbor, which additional task must you perfom to allow the two devices to continue exchanging routes?

Which two features can you enable on a switch to capture and analyze frames that transt an interface? (Choose two)

Which two characteristics of an ICMP echo-based IP SLA are true? (Choose two)

Which two are features of IPv6?(choose two)

Which two statements about Cisco Discovery Protocol are true?(Choose two)

Which two QoS tools can provide congestion management?(Choose two)

Refer to the diagram.

CCNA 200-125 Certification Exam Answers Part 7 q49

All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network? (Choose three.)

A national retail chain needs to design an IP addressing scheme to support a nationwide network. The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per subnet.
Working with only one Class B address, which of the following subnet masks will support an appropriate addressing scheme? (Choose two.)

Which two statements describe key differences between single- and dual-homed WAN connections? (Choose two)

Which two values are needed to run the APIC-EM ACL Analysis tool ?(choose two)

Which QOS feature can drop traffic that exceeds the committed access rate?

Which two criteria must be met to support the ICMP echo IP SLA? (Choose two)

What SNMP message alerts the manager to a condition on the network?

In which STP state does MAC address learning take place on a PortFast-enabled port?

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q57

A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?

For which two reasons might you choose chassis aggregation instead of stacking switches?(Choose two)

Which two benefits of implementing a full-mesh WAN topology are true?(Choose two）

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q60

Traffic on the control plane uses which VLAN?

Which two conditions can be used to elect the spanning-tree root bridge?(choose two）

Which type of device should you use to preserve IP addresses on your network?

What two actions can be taken to secure the virtual teminal interfaces on a router?(choose two)

Which two cable specifications can support 1-Gbps Ethernet? (choose two)

Which value is included in the initial TCP syn message?

At which severity level can syslog logging begin to affect router performance?

Refer to the exhibit.

CCNA 200-125 Certification Exam Answers Part 7 q67

What is the effect of the configuration?

Which effete does the aaa new-model coniguration commandhave?

A BPDU guard is configured on an interface that has PortFast Enable. Which state does the interface enter when it recives a BPDU ?

Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over FastEthernet?